Power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE 1
General Description
This electrical power unit is made solely to the modest lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has been widely utilized while in the marketplace of logistic units for example minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled through the solenoid valve with all the pace managed from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This energy unit is intended exclusively for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as the velocity controlled from the adjustable needle valve. Once the lift rises to a higher positoin, however the energy provide is minimize, the lowering motion is controlled by the guide override function.
Energy UNITS FOR LIFT TABLE three
General Description
This power unit is developed solely to the large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve as well as the speed managed by a strain compensated flow management valve.
Power UNITS FOR LIFT TABLE four
Basic Description
This electrical power unit is created solely to the significant lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve along with the pace controlled through the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power provide is cut, the lowering motion is controlled from the guide override function.
Unique Notes
1. This power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic parts concerned before set up of the power unit.
three. Viscosity in the oil shoud be 15~46 cst,which should also be clean and totally free of impurities.N46 hydraulic oil is advised.
4. Oil modifying is needed after the preliminary 100 operation hrs,afterwards the moment just about every 3000 hours.
5. The power unit shown is created to be mounted vertically.