SMR Gearbox Set up
Satisfactory functionality is determined by suitable set up. lubrication and servicing. for that reason it is vital the directions while in the set up and servicing leaflet. provided with each gearbox. are followed carefully. a number of the critical facets of belt and torque-arm set up are listed beneath.
one. Install pulley on gearbox input shaft as close on the reducer doable, and mount reducer on driven shaft as near to bearing as sensible. failure to carry out this will result in extra loads within the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive with all the belt pull at somewhere around 90° on the center line amongst driven and input shafts. this can allow tensioning with the wedge belt drive using the torque arm which should really preferably be in tension. if output hub runs anti-clockwise. torque arm ought to be positioned the correct.
three. lnstall torque-arm fulcrum on the rigid support so that the torque-arm will likely be at somewhere around proper angles to the center line through the driven shaft as well as torque arm case bolt. ensure there exists adequate take up during the turnbuckle for belt stress adjustment.
Continue to keep close.
Bell drive can be positioned in 
any easy postion. when the torque arm will be to be utilised to tighten the belts, the drive need to be at about tight angle to your line concerning the input and output shafts.
Bell drive can be situated to your proper if desired.
If output hub rotates clock-wise. position belt drive and torque arm in opposite course to that shown in the illustration.
Torque arm and belt get up.
Torque arm may be mounted towards the right if sought after.
SMR Gearbox Installation
Tags