Worldwide conventional chains complying with JIS and ANSI

The 14 sizes of conventional roller chains are available ranging from 25 to 240 which include those in conformity with ANSI (American Y2 Series three-Phase asynchronous Motors National Conventional Institute), and ISO (International Organization for Standardization).
The chains not merely meet the necessities for the minimal tensile strength prescribed by ANSI and ISO, however they also give the top class quality from the world such as a higher fatigue strength
Ideal employs
?Standard use for driving and lifting products.
Examples
?Driving transfer units and other gear. For multilevel parking.
Collection of chains
For variety of a chain, see the tables of “Max. Horsepower Ratings” for normal roller chains and “Designing of Chain Transmission”. Even so, only to get a distinctive situation of low velocity and less shock, “Low-speed selection” strategy may also be referred to.
Regular roller chains as much as 5 strands are available. The typical process for connecting pins and plates is rivet type (RP).
The cotter type (CP) is obtainable for standard chains and HK chains of 80 or greater.
Sprockets
The common roller chains can be engaged with regular sprockets in the corresponding nominal numbers. For sprockets, refer to your table of “Dimensions” for each dimension of chain.
Connecting hyperlinks and offset back links
For connecting hyperlinks and offset back links, refer to your table of “Dimensions” for every size of chain.
The connecting back links are typically R or C connecting links in which the pins are clearance-fitted using the connecting plate. Because clearance-fitted backlinks are inferior to your base chain in Max. allowable tension as within the case of one-pitch offset hyperlinks (OJ), “Low-speed selection” can’t be referred to. Because the Max. kilowatt ratings are determined thinking about the strength of connecting links and OJ, the clearance-fitted connecting backlinks and OJ is often employed if the chains are selected according to your “General selection”. When a increased Max. allowable stress is required for your connecting website link, utilize the interference-fitted connecting link (H connecting link) of a HI-PWR-S chain, and during the case of offset back links, use 2POJ.